Diesel Engine Maintenance & Repair
Diesel IQ is a free resource for Power Stroke and Cummins Diesel engine owners and technicians.
Similar Posts
Monitor ICP While Cranking
Purpose:To determine if the injection control system can supply enough injection control pressure to sustain starting. Recommended Procedure:Connect OBDII Scan Tool to the data link connector (DLC) under the dash. Access ICP PID on Scan tool menu nd monitor ICP reading while cranking the engine. Note: CMP signal is required before injection control pressure is allowed…

Fuel System Bleeding
Controlled venting is provided at the injection pump through the fuel drain manifold. Small amounts of air introduced by changing the filters or injection pump supply line will be vented automatically, if the fuel filter is changed in accordance with the instructions. No manual bleeding of fuel lines is required. NOTE: Manual bleeding is required if:…
Drive Belt Tension Check
Measure the belt deflection at the longest span of the belt. Maximum Deflection: 9.5 to 12.7 mm [3/8 to 1/2 inch] NOTE: The Cummins belt tension gauge, Part No. ST-1293 can be used. Gauge Value: 267 to 578 N [60 to 130 Lbf].

Dodge Ram 8.0 Magnum V10 Engine Specs, Info, Reliability, Problems
The massive 8.0 Magnum V10 was available in the 1994 to 2003 Dodge Ram 2500 and 3500 models. Its 310hp and 450tq made it the most powerful gasoline engine available in a passenger pickup truck. Dodge Ram V10 Magnum engines also offer the full 450 lb-ft of torque at a mere 2,400 RPM’s. The low-end…

Cooling System Maintenance : Coolant Draining
WARNING Avoid prolonged and repeated skin contact with used antifreeze. Such prolonged repeated contact can cause skin disorders or other bodily injury. Avoid excessive contact – wash thoroughly after contact. Keep out of reach of children. Protect the environment: Handling and disposal of used antifreeze can be subject to federal, state, and local…

Drive Belt Inspection
Visually inspect the belt. Check the belt for intersecting cracks. Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable. Replace the belt if it is frayed or has pieces of material missing. Belt Replacement 3/8 Inch Square Drive, 13 mm Remove the…